Canon MultiPASS L60 User Manual page 149

3. Press START/COPY.
N
If an error occurs during sending, the MultiPASS L60 will print out an
error report. If this happens, try sending the fax again. See "Faxing
Problems" on page 11-21 for details about errors.
Chapter 6
The MultiPASS L60 then begins scanning the document into
memory and dials the number:
After a few seconds, the display shows the number of pages it
has scanned:
The display then shows the transaction number for the fax. This
is a unique number the MultiPASS L60 assigns to the document,
and is used to identify the document in transaction reports:
The display continues to show these three displays in order
while the fax is sending.
When the MultiPASS L60 finishes sending the fax, the display
shows the TRANSMITTING OK message:
TX
SCANNING P.001
TX/RX NO. 0002
TRANSMITTING OK
6-21
Sending Faxes