Canon MultiPASS L60 User Manual page 316

Dual access (Multitasking)
Enables the MultiPASS L60 to receive a fax, even if it is copying or
printing a document. Also enables you to load other faxes into memory,
make copies, print out reports, print documents or register information
while the MultiPASS L60 sends a fax from memory.
E
ECM
Error Correction Mode. The ability of your MultiPASS L60 to reduce
system and line errors when sending or receiving from another fax with
ECM capability. ECM is most effective in areas where the telephone
lines are in poor condition or there is frequent interference on the line.
Do not use ECM if you need to send a document quickly and you are
sure the other party can read your transmission without it (turning off
ECM also turns off MMR).
Extension
A telephone connected to the MultiPASS L60 that is used in place of the
handset. You can use the extension telephone to activate incoming
reception of documents manually.
F
Factory default
The MultiPASS L60 is preprogrammed in the factory with settings that
we recommend. These are known as Factory Default Settings. You can
customise your MultiPASS L60 by programming settings other than the
Factory Default Settings.
FAX/TEL switching
This option allows you to set the MultiPASS L60 to automatically detect
whether a call is from a fax or telephone. If the call is from another fax,
the transmission is automatically received. If the call is from a
telephone, the MultiPASS L60 rings to let you know, so you can pick up
the handset. With this feature, one telephone line can be shared by both
the telephone and the fax.
FINE
The resolution setting for documents with very small characters and
lines.
G-4
Glossary