Installing New Access Doors - Cal Flame BBQ870 Owner's Manual

Items Included with Barbecue
1) "T" adapter (3/8")
2) 2 each Hose 3/8" Fittings
3) Regulatorw/ Hose
"T" Adapter (3/8" Threaded)
To grill, located
underneath and
behind grill
From Grill
3/8" Fittings
NOTE: You will need to use a gas rated
sealer on all gas connectors (Tape,
pipe dope, ect.)

Installing New Access Doors

1. Provide a cut out and a door jamb with inside dimensions as follows:
16 1/4" X 19 " for a single door
28 1/4" x 19 3/8" for double doors
2. Secure the steel frame with 16 #10 x 1" truss head phillips screws.
3. Attach doors to frame.
4. Adjust doors as follows:
a. For height adjustment, loosen the two screws attached to each mounting plate.
b. Snap off hinge and secure mounting plate with #6 X 1" flat phillips screws.
c. For side adjustment, turn the screws to increase or decrease door overlay.
d. For depth adjustment, loosen screws, adjust the door to the desired position and retighten the screws.
2006 Barbecue Owner's Manual
LTR20061004, Rev. A
BARBECUE GASLINE
To side burner, located
underneath behind burner.
From Side Burner
To Propane Tank
Gas Line
Figure 22. Side burner installation
Assembly and Installation
Open barbecue door. Install hose with regulator on propane
A
tank. Then connect other end to "T" adapter. Make sure to
use gas rated tape seal when installing adapter to insure
proper seal.
C
B
Grill
A
Then take other end of "T" adapter with hose attached
B
and connect to end of male located underneath and at
the back of the grill. (Use gas rated tape seal on all
connections).
Connect the last open line to the side burner
C
(Use gas rated tape seal on all connections)
Page 19