Cal Flame BBQ870 Owner's Manual page 61

Appendix
Figure 55. Widening the cross flow channel
G3000 Waterfall
• Make sure 110V power is connected to the barbecue island input line.
• Make sure the pump cord is connected to a 110V outlet line.
• Check the water level before turning the pump on.
• Maintain the water level above the submersible pump at all times. Do not exceed the water level above the
barbecue island pond.
• Check the plug to ensure the GFCI breaker is not tripped.
Waterfall Pump Replacement
• Disconnect the main power source to the barbecue island.
• Disconnect the submersible pump from the barbecue outlet line.
• Remove the submersible pump from the barbecue island pond.
• Pull out the pump power cord.
• Insert the power cord of the new submersible pump through the flex pipe.
• Connect the power cord of the submersible pump to the barbecue outlet line.
• Connect the main power source to the barbecue island.
2006 Barbecue Owner's Manual
Page 57
LTR20061004, Rev. A