Installing New Access Doors; Light Switch Installation - Cal Flame MC800 Owner's Manual

Assembly

Installing New Access Doors

Provide a cut out and a door jamb with inside
1.
dimensions as follows:
16 1/4" X 19 " for a single door
28 1/4" x 19 3/8" for double doors
Secure the steel frame with 16 #10 x 1"
2.
truss head phillips screws.
3. Attach doors to frame.
Adjust doors as follows:
4.
For height adjustment,
a.
the two screws attached to each
mounting plate.
b. Snap off hinge and secure mounting
plate with #6 X 1" flat phillips
screws.
For side adjustment, turn the
c.
screws to increase or decrease
door overlay.
For depth adjustment,
d.
screws, adjust the door to the
desired position and retighten the
screws.

Light Switch Installation

If you have the hardware interior island option, you will
need to install the light kit. The kit consists of a 12-volt
light, a wiring harness and a microswitch and bracketry.
The microswitch mounts to the bracket with a supplied
set of screws and nuts.
Once you mount the the switch bracketry, choose a
location for the light. The light can be mounted anywhere
in the island that provides you with the light you need for
your internal storage area.
The 12-volt light portion of your kit will have the necessary
mounting hardware. Be sure to keep the light within the
range of the provided wire harness and the hot portions
of the grill.
Page 6
loosen
loosen
2008 Barbecue Island Owner's Manual
LTR20081036, Rev. A