Table of Contents
Advertisement
Assembly and Installation
Awning Installation
All screws used for the installation of the awning are self-tapping sheet metal screws. No drilling is necessary.
1. Line up the holes for the awning bracket with the corresponding pre-drilled holes on the awning. Use two
carriage bolts for the upper two holes and a flat-head Phillips for the single lower hole. Tighten until snug,
but don't over-tighten (Figure 29A).
2. After mounting the awning bracket, remove the awning from the box. Tilt the awning at a 45Þ angle and
hang the awning onto the awning bracket (Figure 27B).
3. After making sure that the awning is securely hung onto the awning bracket, tilt the awning up to a 45Þ
angle and connect the two male electrical leads securely to the two female electrical leads attached to the
awning. When complete, carefully tuck the wires into the hole and gently lower the awning (Figure 27C).
4. Place set-screws through the awning bracket and awning into the canopy frame. Do not over-tighten (Figure
27D).
Page 24
Figure 28. Canopy final installation
Figure 29. Awning installation
2006 Barbecue Owner's Manual
LTR20061004, Rev. A
Advertisement
Table of Contents
