Installing Drop-In Grills - Cal Flame BBQ870 Owner's Manual

Assembly and Installation
5. Raise the stud from the locking hole and move the burner forward carefully to release it from the ignition
and gas supply valve.
6. Take the burner out of the grill and store it in a safe and dry place.
7. Install the infrared burner. Align the gas inlet on the burner with the gas supply valve on the grill and torch
tube with ignition. Make sure they align perfectly. Slide the stud at the other end into the locking hole.
8. Adjust the infrared burner, make sure the burner is aligned and in position.
9. Install the locking pin. Through the access door underneath the grill, find the stud to lock the burner in
place, install the locking pin. Make sure the locking pin is secured correctly.
10. Repeat steps 2 through 9 if you want to replace other burners.
11. Put back the grate you just removed. (You don't need flame tamer for infrared burners.)
12. Reconnect or turn on the gas line.
You have just successfully replaced the regular burner with infrared burner. If you want to change back to
regular burners, just follow the procedure above in reverse order.

Installing Drop-In Grills

Installing Grills in Modular Carts
IMPORTANT: Keep fingers away from where the grill will be supported on the cart. Your fingers could
become trapped and serious injury could occur.
1. Slowly lower grill unit onto the cart, making sure that screws line up with slots on top of cart (Figure 11).
Ensure that no electrical chords or gas lines become trapped between any part of the cart and any part of
the grill.
Page 12
Figure 10
2006 Barbecue Owner's Manual
LTR20061004, Rev. A