Table of Contents
Advertisement
Assembly and Installation
Barbecue Island Assembly
Stucco and Tile Unit Assembly
1. Place the island sections together on the ground (Figure 12 and 11).
2. Make sure the ground where the barbecue is place is as level as possible for best alignment.
NOTE: If the ground is not level, use shims to level out the island sections. This needs to be done before you
intall the bolts.
3. Connect the speakers, lights, and main power cables before sliding the sections together.
4. Insert the bolts through the pre-drilled holes from the inside of the barbecue island (total of four bolts on
each side) (Figure 14). Tighten all bolts using a 9/16" wrench (Figure 13).
5. Prepare and fill the gap or seam line with speed set (Figure 16).
6. Using your fingertips, push and flatten out the speed set into the seam line (Figure 17).
Page 14
Figure 12
Figure 14
Figure 13
Figure 15
2006 Barbecue Owner's Manual
LTR20061004, Rev. A
Advertisement
Table of Contents
