Table of Contents
Advertisement
2.
Grill should sit flat on cart all the way around. Gently realign cart sides to allow them to sit under outside
lip of grill.
3.
Check that all burner control knobs are in the "OFF" position and attach gas connector to LP tank.
When handling LP gas line and connectors, do not allow them to come in contact with any metal surfaces of the
cart or cabinet. Do not drop LP connectors.
Installing Grills in Barbecue Islands
Before installing grill or side burner in any island or cut out, make sure that the opening is not bigger than the
outside frame of the grill unit. Grill should rest on the lip of the frame. For drop in accessories, adequate cross
ventilation must be designed into enclosure to ensure drop in grill or side burner does not become overheated.
Pay careful attention to the location of gas lines. Gas lines should be routed away from sources of heat and
should make as few bends as possible.
1.
Check to see if gas line connections will be accessible when grill is installed.
a.
If gas line connections are not easily accessible when the grill is installed, support the grill above
counter level and attach the gas lines to the grill. When the gas connections are made, slide the grill
into the cut out.
b.
If gas line connections are accessible when the grill is installed, slide the grill into the cut out and
then attach the gas lines.
Be very careful not to kink gas lines when lowering grill or side burner into cut out.
Keep your fingers away from where the grill will be supported on counter. Your fingers could become
trapped and serious injury could occur.
2.
Check to make sure the grill is level and is supported around the entire outside edge. If the grill is not
level or is unstable, use non-combustible shims under the outside lip to stabilize it.
3.
Perform the leak test procedure as described earlier in this manual.
2006 Barbecue Owner's Manual
LTR20061004, Rev. A
Figure 11. Lowing the grill onto the cart
Assembly and Installation
Page 13
Advertisement
Table of Contents
