Table of Contents
Advertisement
Installing New Access Doors
1.
Provide a cut out and a door jamb with inside
dimensions as follows:
16 1/4" X 19 " for a single door
28 1/4" x 19 3/8" for double doors
2.
Secure the steel frame with 16 #10 x
1" truss head phillips screws.
3.
Attach doors to frame.
4.
Adjust doors as follows:
a.
For height adjustment, loosen
the two screws attached to each
mounting plate.
b.
Snap off hinge and secure
mounting plate with #6 X 1" flat
phillips screws.
c.
For side adjustment, turn the
screws to increase or decrease
door overlay.
d.
For depth adjustment, loosen
screws, adjust the door to the
desired position and retighten the
screws.
Light Switch Installation
If you have the hardware interior island option, you will
need to install the light kit. The kit consists of a 12-volt
light, a wiring harness and a microswitch and bracketry.
The microswitch mounts to the bracket with a supplied
set of screws and nuts.
Once you mount the the switch bracketry, choose
a location for the light. The light can be mounted
anywhere in the island that provides you with the light
you need for your internal storage area.
The 12-volt light portion of your kit will have the
necessary mounting hardware. Be sure to keep the
light within the range of the provided wire harness and
the hot portions of the grill.
2007 Barbecue Island Owner's Manual
LTR20071036, Rev. A
Assembly
Page 7
Advertisement
Table of Contents
