Removing The Feet From A Switch Before Installing It In An Equipment Rack Or On A Wall; Figure 25: Removing The Rubber Feet From A Switch - Allied Telesis CentreCOM GS970M Series Installation Manual

Removing the feet from a switch before installing it in an equipment
rack or on a wall
Before you install the switch in a 19-inch equipment rack or on a wall, you
need to remove the rubber feet, if they are attached to the base of the
switch. To do this, follow these steps:
1. Place the unit upside down on a level, secure surface.
2. Remove the rubber feet with a screwdriver. Figure 25 shows how to do
this on a GS970M/10PS switch.
F 25. R
IGURE EMOVING THE RUBBER FEET FROM A SWITCH
3. Turn the switch back over.
GS9790M Series Switch Installation Guide
55