Removing The Feet Before Installing The Switch In An Equipment Rack Or On A Wall; Figure 13: Removing The Rubber Feet And Rivets From A Switch - Allied Telesis AT-x220-28GS Installation Manual

Removing the feet before installing the switch in an equipment rack or
on a wall
Before you install the switch in a 19-inch equipment rack or on a wall, you
need to remove the rubber feet, if they are attached to the base of the
switch. To do this, follow these steps:
1. Place the unit upside down on a level, secure surface.
2. Use a small flat-head screwdriver to pry the four rubber feet and their
rivets from the bottom of the switch. Figure 13 shows how to do this on
an AT-x220-28GS switch.
Figure 13. Removing the rubber feet and rivets from a switch
3. Turn the switch back over.
Note
The feet are reusable. To re-use them, first push the rivets out of the
feet. Then separate the rivet pin and housing from each other, so
that you can insert them as described in "Installing the switch on a
table or a desktop" on page 23.
AT-x220-28GS Switch Installation Guide
25