Removing The Feet From A Switch Before Installing It In An Equipment Rack Or On A Wall; Figure 14: Removing The Rubber Feet From A Switch - Allied Telesis AT-x230L-17GT Installation Manual

Removing the feet from a switch before installing it in an equipment
rack or on a wall
Before you install the switch in a 19-inch equipment rack or on a wall, you
need to remove the rubber feet, if they are attached to the base of the
switch. To do this, follow these steps:
1. Place the unit upside down on a level, secure surface.
2. Remove the rubber feet with a screwdriver. Figure 14 shows how to do
this on an AT-x230-17GT switch.
F 14. R
IGURE EMOVING THE RUBBER FEET FROM A SWITCH
3. Turn the switch back over.
AT-x230L-17GT and AT-x230L-26GT Switch Installation Guide
33