Table of Contents
Advertisement
Dust Head
4. Raise or lower the up down so that cutting head is sitting on the surface of material.
Adjust the dust head leaving a 1/8" gap between the surface of material and bottom of the
Dust Head. Use the Dust head adjustment screws for moving dust head up and down as
needed.
Planer Alignment
Dust Head Adjust-
ment Screws
Dust Head
WMdoc082019
Planer Alignment
Dust Head
8
8-4
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Slab-Mizer MB200 and is the answer not in the manual?