X 2.5'' Drive Bay Accessory Kit; Figure 62 2.5'' 2-Bay Drive Module - Chenbro RM245 Series User Manual

3-5 2 x 2.5'' Drive Bay Accessory Kit

Chenbro Accessory Kit Product Code: 83H803237-005 for SATA/SAS module.
The 2U product family provides the option to support two 6 Gbps hot-swap SATA SSDs installed to a drive module mounted in the
back of the system.
NOTE:
1. Supported SATA SSDs must not exceed the following power and thermal limits:
1 or 2 SATA SSDs supporting up to 4 W per device with a case temperature rating of 70°C.

1 or 2 SATA SSDs supporting up to 1.5 W per device with a case temperature rating of 60°C.

2. The maximum supported SSD power and thermal limits documented above were based on the thermal testing, a
maximum system configuration with fan redundancy support operating at ambient input air temp of 35°C. The test
system was based on the system models utilizing a maximum number of front and rear drive storage devices with 12
x 3.5" in the front & 2 x 2.5" in the back.
3. Because of thermal limits in this area of the chassis, the rear hot-swap drive bay option cannot support 15.0 mm hard
disk drives in any system configurations.

Figure 62 2.5'' 2-bay drive module

RM245 Series
52
Backplane
│