Pipe Mount - Siemens SITRANS LUT400 Series Operating Instructions Manual

Mounting the remote lid
Note: Remote mounted lid can be mounted up to 5 m from the device using two
optional cable extensions (each 2.5 m in length). For instructions on how to con-
nect an extension cable, see
29.
1. Using the template provided, cut out the necessary hole for the remote LUI display
lid. Place the gasket inside the lid, aligning the mounting holes. Align the back of the
remote display lid with the panel hole cut-out. Mark and drill four holes in the
mounting surface for the four screws (provided).
2. Fasten with a screwdriver and wrench.
Recommended torque on fastening screws for good seal:
Note:
• 1.1 N m
• 10 in-lbs
Please note:
• Recommended mounting: mount to panel, up to 5 m from the device. If alternate
mounting surface is used, it MUST be able to support four times the weight of the
device.
Fasteners included: M5 screw, seal washer, M5 flat washer and nut. These
Note:
fasteners are required to maintain IP65 rating on remote lid.

Pipe mount

enclosure with optional display lid
Note: Pipe mount fasteners not included.
For a more detailed dimension drawing, see
A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
Remote mounted lid with extension cable
mounting back plate
SITRANS LUT400 Dimensions
on page
u-bolt
saddle
clamp
pipe
on page 255.
Page 13