Siemens SITRANS LUT400 Series Operating Instructions Manual page 357

Start of QS Volume Wizard
Note:
The introduction screen is displayed only on the device when using the local
push buttons. This screen is not part of the Quick Start when using SIMATIC PDM.
Shows the type of Wizard to be executed.
Options
Transducer
Specifies the Siemens transducer connected to the device.
Options
Temperature Source
Source of the temperature reading used to adjust the speed of sound.
Options
Temperature Source
See
Fixed Temperature
Use this feature if a temperature sensing device is not used.
Value
This parameter is only displayed if FIXED TEMPERATURE selected for Temperature
Source.
Vessel Shape
Defines the vessel shape and allows the SITRANS LUT400 to calculate volume
instead of level. If NONE is selected, no volume conversion is performed. Select the
vessel shape matching the monitored vessel or reservoir.
Options
Vessel Shape
See
selected, enter values for level and volume breakpoints after completing the wizard
2.6.7. Table 1-8
(see
Units
Sensor measurement units.
Options
For the purpose of this example, all values are assumed to be in meters (m).
Note:
Page 44 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
CANCEL, START
NO TRANSDUCER, XRS-5, XPS-10, XPS-15, XCT-8, XCT-12, XPS-30, XPS-40,
XLT-30, XLT-60, STH
Default: NO TRANSDUCER
TRANSDUCER, FIXED TEMPERATURE, EXTERNAL TS-3, AVGERAGE OF
SENSORS
Default: TRANSDUCER
on page 181 for more details.
Range: -100.0 to +150.0 °C
Default: +20.0 °C
NONE, LINEAR, CYLINDER, PARABOLIC BOTTOM, HALF SPHERE BOTTOM,
FLAT SLOPED BOTTOM, PARABOLIC ENDS, SPHERE, CONICAL BOTTOM,
CURVE TABLE, LINEAR TABLE
Default: LINEAR
on page 147 for illustration. If CURVE TABLE or LINEAR TABLE
on page 150).
M, CM, MM, FT, IN
Default: M
7ML1998MV01