Siemens SITRANS LUT400 Series Operating Instructions Manual page 352

2) Choose Wizards (1.), Quick Start (1.1), and then the appropriate quick start:
QS Level (1.1. 1 .), QS Volume (1. 1 .2.), or QS Flow (1.1.3.).
[The QS Flow wizard will display on LUI for LUT430 (Pump and Flow), and LUT440
(OCM) configured models only.]
3) Follow the steps then choose Finish to save Quick Start parameter changes and
return to Program menu, then press
mode.
Notes:
• The Quick Start Wizard settings are inter-related and changes apply only after you
choose Finish in the final step.
• Perform customization for your application only after the Quick Start has been
completed.
1. Wizards
1.1. Quick Start
1.1.1. QS Level
Use this wizard to configure simple level applications.
a. Press RIGHT arrow
MENU.
b. Press RIGHT arrow
c. Press RIGHT arrow
d. At each step, press DOWN arrow
accept default values and move directly to
the next item,
or RIGHT arrow
current selection is highlighted.
e. Scroll to desired item and press RIGHT arrow
to store the change, then press DOWN
arrow to continue.
f. At any time, you can press UP arrow
go back, or LEFT arrow
A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
three times to return to Measurement
to activate PROGRAM mode and open menu level 1: MAIN
two times to navigate to menu item 1.1. 1 .
to open QS Level.
to
to open Edit mode: the
to
to cancel the wizard.
QUICK START LEVEL
TRANSDUCER
XRS-5
BACK
CANCEL EDIT
NEXT
QUICK START LEVEL
TRANSDUCER
NO TRANSDUCER
XRS-5
XPS-10
XPS-15
XCT-8
XCT-12
Page 39