Connecting The Base Unit And Expansion Modules - Pilz PNOZ m B0 Operating Manua

Installation
5.3

Connecting the base unit and expansion modules

Please refer to the document "System Expansion" for details of the number of modules that
can be connected to the base unit and the module types.
The modules are linked via jumpers.
Remove the terminator on the side of the base unit and on the expansion module.
}
Install the base unit and expansion modules on the mounting rail and connect the units
}
using the jumper supplied
Fit the terminator to the unconnected interfaces on the base unit and expansion mod-
}
ule.
Operating Manual PNOZ m B0
1002660-EN-02
Information
Please note that at the stated minimum distance, it will be difficult to swap
the chip card from above. If you cannot leave a greater distance, remove
the unit from the mounting rail to swap the chip card.
Terminator
X3
X1
X2
X4
ATTENTION!
Only connect the base unit and expansion modules when the supply voltage
is switched off.
Jumper Terminator
IM0 IM1 IM2 IM3 I4 I6 I7
I5
I8 I10 I11 I12 I13 I14 I15
PNOZ mm0.1p
T0 T1 T2 T3 O0 O1 O2 O3
M20 M21 M22 M23
IM16 IM17 IM18 IM19 A1 A2 0 V 24 V
16