Connecting The Base Unit And Expansion Modules - Pilz PNOZmulti Mini Operating Manual

Installation
5.4

Connecting the base unit and expansion modules

The position of the expansion modules is defined in the PNOZmulti Configurator. The ex-
pansion modules are connected to the left or right of the base unit, depending on the type.
Please refer to the document "PNOZmulti System Expansion" for details of the number of
modules that can be connected to the base unit and the module types.
The modules are linked via jumpers.
} Remove the terminator on the side of the base unit and on the expansion module.
}
Before installing the units on the mounting rail, connect the base unit to the expansion
module using the jumper supplied .
}
Fit the appropriate terminator to the unconnected interfaces on the base unit and ex-
pansion module.
–
–
Operating Manual PNOZ mm0p-T
1002704-EN-02
Left-hand side on the base unit and expansion modules to the left of the base unit:
Black/yellow terminator
Right-hand side on the base unit and expansion modules to the right of the base
unit: Yellow terminator
Left terminator
CAUTION!
Only connect the base unit and expansion modules when the supply voltage
is switched off.
Jumper
Right terminator
16