Important Information; Intended Use; Safety Precautions; Electronic Equipment Reception Interference - Assa Abloy SW100 Installation And Service Manual

3

Important information

3.1

Intended use

The door is designed to offer continuous use, a high degree of safety and maximum lifetime. The
system is self-adjusting to the effects caused by normal variations in the weather conditions and
to minor friction changes caused by e.g. dust and dirt.
For escape in emergency situations the doorset is opened manually.
This manual contains the necessary details and instructions for the installation, maintenance and
service of the Swing Door Operator ASSA ABLOY SW100.
The ASSA ABLOY SW100 is an automatic swing door operator developed to facilitate entrances to
buildings and within buildings through swing doors. The ASSA ABLOY SW100 is a low-energy op-
erator using a DC motor and a gear-reduction system to drive an arm system, which opens the
door. It is to be installed indoors where it is suitable for almost all types of external and internal
swing doors. This widely-used operator can be found on applications ranging from handicapped-
access in private homes to high-traffic retail operations.
The motor, oil pump and gear system are combined into a compact unit mounted alongside the
control unit within the cover. The operator is connected to the door leaf with different arm systems.
For use see User manual 1005099.
Save these instructions for future reference.
3.2

Safety precautions

Be sure to complete a risk assessment according to "Guide for installers of Powered Pedestrian
Swing Doors" (PRA-0006) and fill in the "Site Acceptance Test" (PRA-0007) before taking the door
into operation.
To avoid bodily injury, material damage and malfunction of the product, the instructions contained
in this manual must be strictly observed during installation, adjustment, repairs and service etc.
Training is needed to carry out these tasks safely. Only ASSA ABLOY Entrance Systems-trained
technicians should be allowed to carry out these operations.
3.3

Electronic equipment reception interference

The equipment may generate and use radio frequency energy and if not installed and used properly,
it may cause interference to radio, television reception or other radio frequency type systems.
If other equipment does not fully comply with immunity requirements, interference may occur.
There is no guarantee that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Re-orient the receiving antenna.
• Relocate the receiver with respect to the equipment.
• Move the receiver away from the equipment.
• Plug the receiver into a different outlet so that equipment and receiver are on different branch
circuits.
• Check that protective earth (PE) is connected.
If necessary, the user should consult the dealer or an experienced electronics technician for addi-
tional suggestions.
1005088-en-22.0 Issue 2021-02-24
3 Important information
7