Service / Maintenance - Assa Abloy SW100 Installation And Service Manual

18

Service / Maintenance

Regular inspections shall be made according to national regulations and product documentation
by an ASSA ABLOY Entrance Systems-trained and qualified technician. The number of service occa-
sions should be in accordance with national requirements and product documentation. This is
especially important when the installation concerns a fire-approved door or a door with an emer-
gency opening function.
As with all other technical products, an automatic door needs maintenance and service. It is essential
to know the importance of maintenance to have a reliable and safe product.
Service and adjustments will ensure a safe and proper operation of an automatic door unit.
The "Service Log Book" shall be used together with the "Site Acceptance Test and Risk Assessment"
document (PRA-0007) provided. Keep both documents available for maintenance and service re-
cords.
The table below shows the recommended interval in months, when to replace parts during pre-
ventive maintenance.
Transmission unit
PUSH/PUSH-335 service kit
PULL/PULL-220 service kit
Adaptor kit
Door stop (transmission unit
until w.1947)
Stop arm kit (transmission unit
from w.1947)
ST-V/H service kit
Micro switch kit
Battery backup unit *
CU-ESD control unit
* Disconnect mains when replacing battery.
Risk of battery explosion if wrong type of battery is used. If Battery Monitoring DIP is ON, then
a reset of this is needed (after changed batteries), see section 5.4.6.
1005088-en-22.0
Part Part number
331003498
330000271BK/SI
330000335BK/SI
330000270BK/SI
330000230
331019378
331003887
331019159
331003567
331003532
Issue 2021-02-24
18 Service / Maintenance
Cycles/hour in operation
<10 <100 >100
Low Medium High
traffic traffic traffic
60 60 60
24 12 6
24 12 6
24 12 6
24 12 6
24 12 6
24 12 6
24 12 6
24 24 24
60 60 60
Abusive
Environment
60
6
6
6
6
6
6
6
24
60
67