Changing Group Of Parameters (Level 2) - Assa Abloy SW100 Installation And Service Manual

14 Advanced settings
14.3

Changing group of parameters (Level 2)

a Disconnect batteries if any.
b Disconnect the mains.
c Press the LEARN BUTTON (LRN) and keep it depressed.
d Connect the mains.
e Watch the ERROR LED.
3 s
f Release the LEARN BUTTON after 2 flashes (LED is out).
The ERROR LED flashes a number of short flashes that corresponds to the parameter group
number (see table). After a short pause the LED will repeat the group number, and so on.
g Pushing the LEARN BUTTON once, increases the parameter group number. When the highest
parameter group number is reached it will start with number 1 (default) again.
h Push the button until you get the requested parameter group. Ensure that the requested group
of parameters has been selected by counting the number of flashes.
i Disconnect the mains.
j Next time the mains is connected, the operator will use the new group of parameters.
Parameter/ Group 1 (default)
OPEN/CLOSE 15 minutes
HOLD OPEN TIME
BATTERY mode Power Save
KILL mode Locked dur-
ing KILL
OBSTRUCTION Door closer
mode 1)
DOUBLE EGRESS Separate
mode presence de-
tection
LOCK RETRY On
OPEN/CLOSE im- In AUTO
pulse mode
KILL Impulse Normally
Configuration Open
1)
If set to REVERSES WHEN OBSTRUCTED, the operator re-opens when obstructed, similar to a presence impulse.
As default the operator tries to close two times extra in automatic operation, OFF or EXIT mode and one time in manual operation, OFF or
EXIT mode if there is a problem with binding striking plates. This function can be switched off (see LOCK RETRY above).
Note! When changing group of parameters, normally only the primary control must be configured in a double door application. When
changing from or to group seven, both primary and secondary must be configured.
58
1 s 3 s
2 3
Infinite 15 minutes 15 minutes
Power Save Convenience Power Save
Locked dur- Locked during Lock follows
ing KILL KILL program se-
lector during
KILL
Door closer Door closer Door closer
Separate Separate pres- Separate
presence de- ence detec- presence de-
tection tion tection
On On On
In AUTO In AUTO In AUTO
mode mode mode
Normally Normally Normally
Open Open Open
Issue 2021-02-24
4 5 6
15 minutes 15 minutes
Power Save Power Save
Locked dur- Locked dur-
ing KILL ing KILL
Reverses Door closer
when ob-
structed
Separate Common
presence de- presence de-
tection tection
On On
In AUTO In AUTO
mode mode
Normally Normally
Open Open
7 8
15 minutes 15 minutes 15 minutes
Power Save Power Save Power Save
Locked dur- Locked dur- Lock follows
ing KILL ing KILL program se-
lector during
KILL
Door closer Door closer Door closer
Separate Separate Separate pres-
presence de- presence de- ence detec-
tection tection tion
Off On On
In AUTO In OFF, EXIT In AUTO
mode and AUTO mode
mode
Normally Normally Normally
Open Open Closed
1005088-en-22.0
9 10
15 minutes
Convenience
Locked dur-
ing KILL
Reverses
when ob-
structed
Separate
presence de-
tection
On
In AUTO
mode
Normally
Open