Cover; Fitting And Removing The Cover - Assa Abloy SW100 Installation And Service Manual

12 Cover

12 Cover
The cover and back plate are manufactured in clear anodized aluminium. The end plates are made
of black painted steel sheet.
12.1

Fitting and removing the cover

The cover is slid over flanges in the back plate so that the ridges fit in the grooves.
Break off and snap on the fill cover into the back plate for output shaft. Snap on the other fill cover
for the second slot. Secure cover with the screw.
When properly installed and adjusted, attach the product label, which includes the CE mark on the
right side of the lower part of the operator cover (see illustration).
Apply the ASSA ABLOY logotype to the cover see illustration.
Only for SE: Apply the SITAC label next to the product label - see illustration.
54
25
Issue 2021-02-24
XXXXXXX XXXXXXXXXXXXX XXXXXXXXXX
ART. NO. DESIGNATION TYPE
XXXXXX XXXX XXXXXXXXXXX
PROJECT/SERIAL NO. YEAR+WEEK TEMPERATURE
Ersätter lås med fallkolv till
XXXXXXX XXXX XXX XX/XX XXXXX
typgodkända
VAC A W Hz LOAD
slagdörrar enl. förteckning
XXXXXXX
Skydd mot olyckor vid 1 2 3 4 5 6 7 8
PROD. ORDER
rörliga anordningar
CLASSIFICATION DIN 18650
CERTIFIERING CERTIFIERING
KONTROLL KONTROLL
1002 SÜD 1002 xxxxxxx
xxxxxxx
Part of the Besam range
1005088-en-22.0