Important Information - Assa Abloy Besam PowerSwing CSDB Installation And Service Manual

Swing door operator

Hide thumbs

Table Of Contents

Table of Contents

2.1

Important notice

2.2

Electronic equipment reception interference

2.3

Environmental requirements

1004935-US-1.0

To avoid bodily injury, material damage and malfunction of the product, the instruc-

tions contained in this manual must be strictly observed during installation, adjust-

ment, repairs and service etc. Only Besam-trained technicians should be allowed to

carry out these operations. Save these instructions.

This equipment may generate and use radio frequency energy and if not installed and

used properly, that is, in strict accordance with the manufacturer's instructions, it may

cause interference to radio, television reception or other radio frequency type sys-

tems. It has been designed to comply with the emission limits in accordance with EN

61000-6-3 (US market FCC Part 15), which are designed to provide reasonable pro-

tection against such interference in a residential installation.

However, there is no guarantee that interference will not occur in a particular installa-

tion. If this equipment does cause interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

• Re-orient the receiving antenna.

• Relocate the receiver with respect to the equipment.

• Move the receiver away from the equipment.

• Plug the receiver into a different outlet so that equipment and receiver are on dif-

ferent branch circuits.

• Check that protective earth (PE) is connected.

If necessary, the user should consult the dealer or an experienced electronic techni-

cian for additional suggestions.

Besam products are equipped with electronics and may also be equipped with batter-

ies containing materials which are hazardous to the environment. Remove this mate-

rial from the operator before it is scrapped and make sure that it is disposed of safely

as was done with the packaging.

Issue 2008-11-13