Table of Contents
Advertisement
Installation
7. Run the lift up until the platform reaches the
vehicle floor. Loosen the cylinder boots.
8. Undo lock screw (A) on the tilt cylinder installed
on the platform. Screw the stop all the way back
(B) toward the platform. See Picture 32.
9. Tilt the platform down to max 10º below the
horizontal. See Picture 31.
m
WARNING!
To ensure lift safety and CE compliance, adjust
the downward tilt angle to no more than 10º.
10. Adjust the end stop all the way to the top of the
cylinder (C). Picture 32.
11. Fix the setting with the lock screw (A).
See Picture 32. Tightening torque: 3-5 Nm
12. Loosen the lock screw (A) on the other tilt cylin-
der.
13. Turn the adjuster sleeve so that the tilt cylinder
fits into the attachment point on the platform
and then fix this setting using lock screw (A).
14. Install the other tilt cylinder in the platform
attachment point. Use the enclosed shaft and
screw. Tighten the screw. Tightening torque: 80
Nm
NOTE!
Make sure the cylinder is installed with the grease
nipple facing up.
15. Fit the tilt cylinder boots.
16. Fit the support wheel on the shaft. Secure with
associated split pin.
17. Test all functions.
www.zepro.com
Max 10º
Picture 31. The downward tilt angle
must be adjusted to max. 10°
A
Picture 32. End stop with lock screw
Picture 33. Install the tilt cylinder on the platform
ZS MK2
B
C
25
Advertisement
Table of Contents
