Connection Of Controller And Warning Lights; Cable Grommet - Zepro ZS MK2 Installation Instructions Manual

Tail lift

Hide thumbs Also See for ZS MK2:

Table of Contents

Connection of controller and warning lights

7.1

7.1.1

Before installing cabling

To be able to install cables in the cable grommet, its protective cover must be removed and the five screws loos-

ened.

1. Disconnect the cable grommet's protective cover, which is secured with three screws, see Picture 46.

2. Loosen the five screws on the cable grommet, see Picture 48. Cables can now be installed/removed/ad-

justed in the grommet. When installing the cable, it should be done together with existing cabling using

cable ties. Ensure the length of the cable is sufficient for moving the control card. The outer sheathing on

cables that connect to the control card must be stripped 350 mm, see Picture 47.

7.1.2

After installing cabling

1. When all cables are suitably located in the cable grommet, tighten the five screws, see Picture 48.

Tightening torque: 5 Nm.

2. Install the cable grommet's protective cover with the three supplied bolts, see Picture 46.

Tightening torque: 8 Nm.

Picture 46. The cable grommet's protective

cover is fastened in place with three screws

Picture 47. The outer sheathing on cables that connect to the control card has to be stripped 350 mm.

www.zepro.com

Picture 48. Cable grommet's five screws

350 mm.

ZS MK2

Table of Contents

Connection of controller and warning lights