Table of Contents
Advertisement
Installation
ZS MK2
5.2
Setting the work position
If necessary, the working position of the tail lift can be adjusted forwards (max. 55 mm). The adjustment op-
tion can be extended by installing a longer adjustment screw (M12). However, the screw should be no longer
than 150 mm. which allows adjustment up to approx. 125 mm. If further adjustment is needed, see section
5.3.
Comment
The space for adjusting the working position forwards is limited by the length of the platform. Make sure the platform can
be unfolded into the intended working position after installation.
1. Unscrew the rear end caps on both slide profiles.
2. Loosen the adjusting screws' counter-nuts.
3. Adjust the lift to the correct working position using the adjusting screws.
IMPORTANT!
It is important that the adjustment is made equally on the left and right sides.
4. Lock the adjustment by tightening the counter-nuts.
5. Screw the end caps on to both slide profiles.
Picture 25. The slide profile's end cap
Picture 26. Screw for setting the work position
22
www.zepro.com
Advertisement
Table of Contents
