Installing The Front Mounting Front Perc Module - Dell EMC PowerEdge GPH2C Installation And Service Manual

Figure 85. Removing the front mounting front PERC module for 8x2.5-inch system
Next steps
Replace the front mounting front PERC

Installing the front mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the drive backplane
4. If installed, remove the air
5. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Connect the PERC cable to the front PERC module.
2. Align the front PERC module at an angle until the tray touches the slot in the system.
3. Press the front PERC module connector with the connector on the drive backplane until firmly seated.
4. Using a Phillips #2 screwdriver, tighten the thumbscrews on the front PERC module.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
module.
Safety instructions.
Before working inside your
cover.
shroud.
system.
Installing and removing system components 83