Table of Contents
Advertisement
Figure 108. Removing the front mounting front PERC module
Next steps
Replace the front mounting front PERC module
Installing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
2. Follow the procedure listed in
Before working inside your
system.
3. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the connectors on the front PERC module with the connectors on the drive backplane.
2. Slide the front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
NOTE:
The front mounted front PERC module is only shipped with 8 x 3.5-inch backplane configuration.
Installing and removing system components
113
Advertisement
Table of Contents
