Brother DCP-9010CN Network User's Manual page 95
Multi-protocol on-board ethernet multi-function print server and wireless (ieee 802.11b/g) ethernet multi-function print server
Hide thumbs
Also See for DCP-9010CN:
- Service manual (598 pages) ,
- User manual (215 pages) ,
- Network user's manual (203 pages)
Table of Contents
Advertisement
Wireless configuration for Macintosh using the Brother installer application (MFC-9320CW only)
k
To communicate with the un-configured wireless machine, temporarily change the wireless settings on
your computer to match the machine's default settings shown on this screen. Check the box after you
confirm these settings, and then click Next.
Note
You can temporarily change the wireless settings on your computer, following the steps below:
1
Click the AirPort status icon.
2
Select SETUP from the pull-down list.
3
Your wireless network is connected successfully.
l
Choose the machine you wish to configure, and click Next. If the list is blank, check if the machine is
powered on, and then click Refresh.
Note
• The default Node name is "BRWxxxxxxxxxxxx". ("xxxxxxxxxxxx" is your machine's MAC Address /
Ethernet Address.)
• You can find your machine's MAC Address / Ethernet Address by printing out the Network Configuration
List. See Printing the Network Configuration List on page 118.
5
84
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
