Using The Pin Method Of Wi-Fi Protected Setup - Brother DCP-9010CN Network User's Manual

Configuring your machine for a wireless network (For MFC-9320CW)

Using the PIN Method of Wi-Fi Protected Setup

If your wireless access point/router supports Wi-Fi Protected Setup (PIN Method), you can configure the
machine easily. The PIN (Personal Identification Number) Method is one of the connection methods
developed by the Wi-Fi Alliance
Registrar (a device that manages the wireless LAN), you can setup the wireless network and security
settings. See the user's guide for your wireless access point/router for instructions on how to access the
Wi-Fi Protected Setup mode.
Note
Routers or access points that support Wi-Fi Protected Setup have a symbol as shown below.
a
Plug the machine's power cord into the AC power outlet. Turn on the machine's power switch.
b
Press Menu, 7, 2, 7. Using a or b, choose On and press OK.
Press Stop/Exit.
WLAN Enable
On
c
Press Menu, 7, 2, 4 for WPS w/PIN Code.
d
The LCD will show an 8 digit PIN and the machine starts searching for an access point for 5 minutes.
Connecting WPS
PIN:XXXXXXXX
e
Using a computer that is on the network, type "http://access point's IP address/" into your
browser. (Where "access point's IP address" is the IP address of the device that is used as the
1
Registrar .) Go to the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD
shows in d to the Registrar and follow the on-screen instructions.
1
The Registrar is normally the access point/router.
Note
The setting page is different, depending on the brand of access point/router. See the instruction manual
that came with your access point/router.
®
. By inputting a PIN which is created by an Enrollee (your machine) to the
3
3
37