Brother DCP-9010CN Network User's Manual page 63

Wireless configuration for Windows
l
If the LCD shows Connected, the machine has successfully connected to your access point/router. You
can now use your machine in a wireless network.
If the LCD shows Connection Error, a session overlap has been detected. The machine has
detected more than one access point/router on your network with the SecureEasySetup™ mode, the
Wi-Fi Protected Setup mode or AOSS™ mode enabled. Make sure that only one access point/router has
the SecureEasySetup™ mode, the Wi-Fi Protected Setup mode or the AOSS™ mode enabled and try
starting from i again.
If the LCD shows No Access Point, the machine has not detected your access point/router on your
network with the SecureEasySetup™ mode, the Wi-Fi Protected Setup mode or AOSS™ mode
enabled. Move the machine closer to your access point/router and try starting from i again.
If the LCD shows Connection Fail, the machine has not successfully connected to your access
point/router. Try starting from i again. If the same message is indicated again, reset the machine back
to the default factory settings and try again. (For resetting, see Restoring the network settings to factory
default on page 117.)
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows
Setting WLAN
Connecting SES
Connecting WPS
Connecting AOSS
Connected
Connection Error
No Access Point
Connection Fail
®
using the Brother installer application (For MFC-9320CW)
Connection status
Searching or accessing the access
point, and downloading settings from the
access point.
Connecting the access point.
Connection succeeded.
Session overlap has been detected.
The access point detection failed.
Connection failed.
Action
—
—
—
Check that only one router or access point has
the SecureEasySetup™ mode, the Wi-Fi
Protected Setup mode or AOSS™ mode enabled
and try starting from step i again.
Move the machine closer to your access
point/router and try starting from step i again.
1 Try starting from step i again.
2 If the same message continues, reset the
machine back to the factory settings and try
again.
4
52