Yamaha T8 Rigging Manual page 334

Outboard Rigging Guide - 2001
Completion Check
Static Check
1. Check the shift operation for smooth shifting
into Forward, Neutral and Reverse.
2. Check the throttle operation for smooth oper-
ation from fully closed to fully open.
N O T E : Shift into forward and then check the
throttle operation.
3. Check the steering friction for proper friction,
then check the tiller handle tilt up/down
motion and make sure the cables and wires
are not stretched.
4. Check the power trim/tilt switch.
a. Connect the battery.
b. Push and hold the switch to "UP", the
motor will tilt up.
c. Push and hold the switch to "DN", the
motor will tilt down.
d. Release the switch, the motor will stop at
its current position.
Dynamic Check
CAUTION:
T he engine is going to be started for checking.
T herefore the engine should be supplied cool-
ing water.
Before performing the dynamic check, make sure
the following conditions are met:
• Lock plate is installed to the engine stop
switch.
• Shift position is neutral.
• Insert the key into the main switch, and turn
to the "OFF" position.
• Throttle control is fully closed.
5. Check the start in gear protection.
a. Shift into forward/reverse.
b. Turn the key to "START." The starter
motor should not turn over.
c. Shift into neutral.
d. Turn the key to "START." The starter
motor will turn over.
6-54
C90/90 Tiller Handle &
Steering Friction Kit