Configuring Http And Https - Digi CM 32 User Manual

Configuring HTTP and HTTPS

6. Press ESC when done to return to the main configuration menu.
7. Enter number 6 to Save changes.
Configuring HTTP and HTTPS
By default HTTP and HTTPS are enabled on the Digi CM device. To modify
these settings, do the following:
1. Enter the IP address for the Digi CM in a web browser's URL.
2. Choose Web server configuration from the Network Configuration heading
3. Choose Enabled or Disabled.
4. Set the desired refresh rate for statistics data.
5. Choose Save to flash and Apply changes.
Access Using SSH
The Digi CM can also be accessed through an SSH connection. The Port
Access Menu and each individual port can be configured for SSH. Access an
The Digi CM
individual port for SSH by doing the following:
supports Blowfish
and 3DES
1. Access the web interface.
encryption methods
for SSH.
2. Use the username admin and the default password admin.
3. Under the Serial Port heading choose Configuration.
4. Choose the port or ports you want to configure for SSH, you can choose
5. Choose Host mode configuration.
16
The values are saved and applied immediately. There is no need to reboot.
on the web interface menu.
The default value is 10 seconds.
either: Port Access Menu, All ports, or an Individual port.
Chapter 2