Power Up The Node; Verify The Operation Of A Replacement M.2 Boot Module Adaptor - Dell EMC PowerStore 1000 Installation And Service Manual
Hide thumbs
Also See for EMC PowerStore 1000:
- Owner's manual (210 pages) ,
- Removing the hard drive (9 pages) ,
- Setup manual (2 pages)
Table of Contents
Advertisement
Figure 103. Sliding the node halfway into the chassis
3. Pull the black release tab out completely, and slide the rest of the node back into the chassis.
The black release tab slides back into the system as it is inserted.
Figure 104. Installing the node
4. Pull the orange release trigger and push in gently to re-engage the locking mechanism.
If the black release tab comes out when pulled, the locking mechanism is not engaged.
Power up the node
Power up the node as described in
Verify the operation of a replacement M.2 boot module adaptor
About this task
The M.2 boot module adaptor is not visible in PowerStore Manager, but you can view the associated internal M.2 boot module.
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the M.2 boot module adaptor.
Power control
procedures.
Base enclosure service procedures
83
Hide quick links:
Advertisement
Table of Contents
