Figure 108. Releasing the top cover
2. Lift the top cover upward, and remove it from the node.
Figure 109. Removing the top cover
Transfer parts from the faulted node to the replacement node
Transfer the following components from the faulted node to the corresponding locations in the replacement node.
To help ensure the correct placement in the enclosure, transfer only one component at a time.
NOTE:
Confirm that all parts are fully seated before inserting the node into the base enclosure.
NOTE:
Do not add any components while the node is powering on.
● Transfer the
power
supply.
● Transfer the
I/O modules
● Transfer the
embedded module
● Transfer the
internal M.2 boot modules
● Transfer DIMMs.
NOTE:
Move DIMMs one at a time from the faulted node to the same slot on the replacement node.
● Transfer
internal
fans.
and fillers.
without removing the 4-port card.
without removing them from the adapters.
Base enclosure service procedures
87