Figure 77. Sliding the node halfway into the chassis
3. Pull the black release tab out completely, and slide the rest of the node back into the chassis.
The black release tab slides back into the system as it is inserted.
Figure 78. Installing the node
4. Pull the orange release trigger and push in gently to re-engage the locking mechanism.
If the black release tab comes out when pulled, the locking mechanism is not engaged.
Power up the node
Power up the node as described in
Verify the operation of a replacement DIMM
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the DIMM.
3. On the Components card, under Internal View, expand the node that includes the DIMM, and then select the relevant
DIMM.
Power control
procedures.
Base enclosure service procedures
67