Power Down The Node; Remove A Faulted Embedded Module - Dell EMC PowerStore 1000 Installation And Service Manual

Table 2. Embedded module LEDs (continued)
LED
Port link
Node fault
Node power
Unsafe to remove

Power down the node

Power down the node as described in

Remove a faulted embedded module

Steps
1. Label and disconnect all cables that are attached to the embedded module.
CAUTION: Do not pull the node from the base enclosure. Pulling the node from the base enclosure disrupts
the system cache.
2. Push the orange tab on the embedded module to release the lever.
Location
Power control procedures.
State Description
Off No link established.
Green Link up with high speed.
Amber Link up with degraded speed.
Off Link down.
Amber Fault has occurred in the node or one of
its components.
Off No fault has occurred. Normal operation.
Green Node is on (main power).
Off Node is off.
White Do not remove the node. Improper
removal could cause data loss.
Off Safe to remove the node when the node
has been properly prepared.
Base enclosure service procedures 37