Install The Top Cover On The Node - Dell EMC PowerStore 1000 Installation And Service Manual

Figure 86. Installing the internal M.2 boot module into the M.2 boot module adaptor
4. Touching only the outside edges of the M.2 boot module adaptor, align the M.2 boot module adaptor with the connector.
5. Firmly push the M.2 boot module adaptor straight down into the connector.
When the M.2 boot module adaptor is fully seated, you will hear a snap, and feel the connector latches click into place.
Figure 87. Installing the M.2 boot module adaptor

Install the top cover on the node

Steps
1. Position the top cover over the node and align it with the slots in the sides at the rear of the node.
Base enclosure service procedures 73