Installing The Front Bezel - Dell EMC PowerStore 1000 Installation And Service Manual

Figure 15. Installing a drive
The activity light flashes to indicate that the spin-up sequence has begun.

Installing the front bezel

Prerequisites
CAUTION: If the protective plastic strip is present on the front of the bezel, it must be removed before placing
the system into operation. Failure to remove the protective plastic strip will cause the system to overheat.
About this task
Refer to Installing the bezel
Steps
1. If present, remove the protective plastic strip from the front of the bezel.
2. Align the bezel with the enclosure.
3. Gently push the bezel into place on the cabinet until it latches.
4. If the bezel has a key lock, lock the bezel with the provided key.
Figure 16. Installing the bezel
on page 23 while performing the procedure that follows.
Install a new base enclosure and optional expansion enclosure
CL5262
23