Dell EMC PowerStore 1000 Installation And Service Manual page 55

NOTE: Do not remove any cables from the other node.
3. Pull the orange release trigger while gently pushing in on the node.
The hook disengages from the locking mechanism, and the release tab slides out.
NOTE: The node comes completely out of the chassis. Be prepared to support the node to avoid dropping it.
NOTE: The release trigger and handle for node B is on the top left. The release trigger and handle for node A is on the
bottom right.
CAUTION: Removing the incorrect node will lead to loss of system power and cached data will be lost.
Figure 56. Disengaging the locking mechanism for node B
4. Before removing the node, ensure that the wire bail is properly secured to the power supply cable of the other node to
prevent accidental loss of power and cache.
5. Use the release handle to pull the node outward enough to grasp the sides with both hands. Then, with both hands
supporting the node, pull the node fully out of the enclosure.
Figure 57. Removing the node
6. Place the node on a clean, flat, static-free work surface.
Base enclosure service procedures 55