Install The M.2 Boot Module Adaptor - Dell EMC PowerStore 1000 Installation And Service Manual

Figure 97. Removing the M.2 boot module adaptor
4. Remove the internal M.2 boot modules:
a. Gently pull the handle on the release tab to separate it from the tab holding it in place.
b. Gently pull straight up on the pull tab to free it from the M.2 boot module adaptor.
c. Remove the internal M.2 boot module from the M.2 boot module adaptor.
Figure 98. Removing the internal M.2 boot modules from the M.2 boot module adaptor

Install the M.2 boot module adaptor

Steps
1. Place the internal M.2 boot modules that you removed from the faulted M.2 boot module adaptor into the new M.2 boot
module adaptor.
NOTE: The side of the internal M.2 boot module with the barcodes should be facing up.
2. Align the blue tab on the replacement internal M.2 boot module with the slot on the M.2 boot module adaptor and gently
push it into place.
3. Connect the pull tab to the blue adapter.
80 Base enclosure service procedures