Replacing Controller Cables - NuVinci enviolo CT Assembly Instruction Manual

Care and Maintenance
WEAR PARTS AND REPAIR WORK
A
B
enviolo Assembly Instruction
Replacing Controller
Cables
REMOVING Controller CABLES
1.
Remove the cable hardware from both cables and remove
the shift cables from housing.
[A]
2.
Remove the phillips screw on the bottom of the manual
controller and remove the bottom cover by pulling lightly on
the access tab.
[B]
3.
Using a small flat screwdriver or pointed object, extract the
cable anchors and shift cables from the grip pulley. Rotate the
grip to access individual cable anchors.
INSTALLING Controller CABLES
4.
Install one shift cable, allowing the controller housing to guide
the cable around the internals until it comes out the other side.
Guide the cable through the closest barrel adjuster (F).
[B]
5.
Pull the cable through the barrel adjuster until the cable
anchor seats fully into the grip pulley (G).
[A]
6.
Rotate the grip to position the next cable for installation and
repeat step 4. and step 5.
[A]
7.
Reinstall the bottom cover and screw (A). Torque to 0.2-0.3
Nm (2-3 in-lbs).
46