NuVinci enviolo CT Assembly Instruction Manual page 41

Quick Start Guide
AUTOMATiQ
3. Calibration continued
A
B
enviolo Assembly Instruction
[A] enviolo AUTOMATiQ calibration - Bosch Intuvia
When
•
After enviolo AUTOMATiQ assembly;
•
After firmware update;
•
When system functions are not appropriate.
How to - for Intuvia
•
Turn on the Bosch Intuvia system. Select no motor assist
•
Activate the "configuration mode" through simultaneous
push and hold of [RESET] and [i] buttons (A).
•
Push the [i] button, until you can see "gear calibration" on
the screen.
•
Lift up the rear wheel and pedal fast and easy.
•
While pedaling, press the "Light" button (B) to start calibration
•
Continue to pedal while the system shifts from full overdrive to
full underdrive several times to complete the calibration process.
•
After completion of the calibration process, the system returns
to the ride mode automatically.
[B] enviolo AUTOMATiQ calibration - Bosch Nyon
When
•
After enviolo AUTOMATiQ assembly;
•
After firmware update;
•
When system functions are not appropriate.
How to - for Nyon
•
Turn on the Bosch Nyon system. Select no motor assist.
•
Enter the menu by moving the joystick to the left.
•
Select "Settings" and confirm by pressing the joystick.
•
Select "My eBike" and confirm by pressing the joystick.
•
Select "eShift (NuVinci)" and confirm by pressing the joystick.
•
Select "Gear calibration" and confirm by pressing the joystick.
•
Lift up the rear wheel and pedal fast and easy.
•
While pedaling, select "Continue" by pressing the joystick to start
the calibration.
•
Continue to pedal while the system shifts from full overdrive to full
underdrive several times to complete the calibration process and
the screen indicates "Gear calibration successful".
•
After completion of the calibration process exit the menu.
41