Servicing Or Replacing The Freewheel - NuVinci enviolo CT Assembly Instruction Manual

Care and Maintenance
WEAR PARTS AND REPAIR WORK
C
16
D
E
enviolo Assembly Instruction
15
18
Servicing or
replacing the
freewheel
1.
Remove the rear wheel.
2.
Remove the hub interface.
3.
Reference the exploded view in chapter 2,
page 9. Remove the sprocket snap ring (16),
sprocket spacer (15, if installed) and sprocket (18).
[C]
4.
Remove the snap ring (15) on the shift driver,
and remove the freewheel assembly (16).
5.
If servicing or replacing, use a medium-weight oil
or very lightweight water-resistant grease and
check pawl and spring function.
19
[D]
6.
Remove the interior snap ring (17), needle
bearing (18), and right hand shield (19) if these
17
components are being replaced.
[E]
7.
Install the serviced/new freewheel
components .
8.
Install the sprocket and hub interface.
9.
Install the rear wheel.
Set the enviolo hub in full overdrive with
the controller or manual hub interface
prior to removal.
47