NuVinci enviolo CT Assembly Instruction Manual page 51

Care and Maintenance
WARE PARTS AND REPAIR WORK
H
B
I
J
enviolo Assembly Instruction
4. Resetting the internal
gear hub to full overdrive
(only applicable to manual variants)
A
H
1. If the manual hub interface is incorrectly installed, full ratio range
of the internal gear hub may be unavailable and full overdrive will
need to be reset.
2. If installed on the bicycle, shift the hub into overdrive "H" as far as
possible and remove the rear wheel per chapter 4.
[H]
3.
Remove the right hand nut (A) that secures the manual hub
interface, then remove the manual hub interface (B) by lifting
carefully from underneath.
For enviolo P Internal gear hubs
D
Remove the right hand nut and axle screw that secure the manual
hub interface, then remove the manual hub interface (B) by lifting
carefully from underneath.
C
[I]
4.
aligned, full overdrive will need to be reset.
5. If the markings are not obvious, full overdrive depending on the
internal gear hub should result in the hub/wheel rotating ~1.6-2
times for every rotation of the sprocket. Also see your internal
gear hub specification for the corresponding full overdrive ratio.
[J]
6.
L position (note this is opposite of normal installation). Reinstall the
manual hub interface (angular position is unimportant), leaving
the right hand nut uninstalled.
For enviolo CT/TR/CO/CA internal gear hubs
If the spline nut (C) and shift drive (D) markings are not
Set the manual hub interface to the full underdrive "L"
51