Installing The Automatiq Controller - NuVinci enviolo CT Assembly Instruction Manual

AUTOMATiQ system:

INSTALLING THE AUTOMATiQ CONTROLLER

RAL7016
J
Bracket
Black
K
For enviolo CO and CA controllers, also note:
Assembly on the left side of the handlebar
After you have installed the enviolo CO on the left side, please press and hold the upper
and middle buttons (and) for about 2 seconds.
Once the Status LED turns green for 2 seconds, the remote control is set to the left side
of the handlebar.
Assembly on the right side of the handlebar
After you have installed the enviolo CO on the right side, please press and hold the
upper and middle buttons (and) for about 2 seconds.
Once the Status LED turns red for 2 seconds, the remote control is set to the right side of
the handlebar.
For the enviolo SP controller we use an LR44
The battery of the controllers can be changed without special knowledge and by using a
50 euro cent coin.
For this purpose, a standard CR2032 battery is required, which is inserted into the new
remote control.
enviolo Assembly Instruction


INSTALLING THE ENVIOLO CA
CONTROLLER
•
Install the right brake lever and grip
according to the manufacturer's
instruction.
•
Push the controller bracket over the
22.2mm handlebar. Use the adapter ring
if installing.
•
Position the controller such that
the buttons are positioned slightly under
the handlebar and comfortable for
thumb controls.
•
Tighten the controller clamp to 1.5-
2.0Nm with a 2.5mm allen wrench.
INSTALLING THE ENVIOLO CO
CONTROLLER
•
Install the right hand grip onto the
handlebar according to the
manufacturer's instructions.
•
Slide the clamp over the handlebar and
tighten it to 1.0-2.0Nm with a 3mm allen
wrench.
•
Position the controller such that the
button can be easily reached with the
thumb, while riding.
•
The enviolo CO controller can be
mounted to either right or left side of
the handlebar.
INSTALLING THE ENVIOLO SP
CONTROLLER
•
Install the right hand grip and brake lever
onto the handlebar according to the
manufacturer's instructions.
•
Slide the clamp over the handlebar and
tighten it to 1Nm with a torx XX
•
Position the controller such that the
button is positioned slightly under and
comfortable for thumb controls.
•
The enviolo SP controller can be
mounted to either right or left side of
the handlebar.
36