NuVinci enviolo CT Assembly Instruction Manual page 21

Table of Contents

Advertisement

Manual system:
INSTALLING THE SHIFT CABLES
N
O
120mm for Standard controller
P
82mm for One-Turn
enviolo Assembly Instruction
Install cable end hardware only by pulling
cables at the end of the housing.
Never rotate the grip with cables
unattached, as they can bind inside the
barrel adjuster.
Pass the shift cables through the
appropriate cable housing and ensure
the housing is seated completely into the
shifter.
Thread both barrel adjusters completely
clockwise (in) to provide maximum
installation slack.
Pull the underdrive shift cable, marked
green or black, firmly at the rear
axle location until it stops, checking
to make sure that the shift indicator [N]
goes completely flat (enviolo TR and SP
controllers), or that the grip rotates
fully in the counter-clockwise direction
shown (enviolo CT, CA and CO shifter,
viewed from the right side of the bicycle).
Pass the underdrive shift cable through
the UD cable stop [O&P] and secure the
UD cable stop at the distance shown
[O&P] while pulling the cable firmly.
Ensure that the cable housing is seated
fully at the barrel adjuster.
Using a 2mm allen, secure the cable and
torque to 1.5-2.0 Nm (13-18 in-lbs).
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enviolo coEnviolo trEnviolo caEnviolo sp

Table of Contents