Installing The Manual Hub Interface - NuVinci enviolo CT Assembly Instruction Manual

Manual system:

INSTALLING THE MANUAL HUB INTERFACE

F
G
H
I
enviolo Assembly Instruction
Installing the Manual Hub
Interface
•
[F] Remove the anti-shift retainer, if installed and ensure that
markings between the splined nut and the shift driver are aligned.
•
[H] Prior to installation, set the hub interface to the full overdrive
position.
•
Suspend the hub interface over the right hand axle, and align the axle
flats with the installation angle.
•
Alternatively, a no-turn washer can be installed over the interface to
align the installation angle.
•
When the installation angle is aligned, ensure the hub interface is
set to full overdrive and seat the hub interface fully onto the shift driver
andt he spline nut until it is flush with the spline nut, as shown.
•
Thread the r.h. nut , serrations facing outward, onto the axle and
tighten to 10-15 Nm (7-11 ft-lbs). Install the rear wheel.
•
[I] For the variant enviolo SP 135 mm:
Thread the adapter shafts into the hub and tighten to 10-15Nm.
•
[J] For the variants enviolo SP 142/148 mm:
Place the spacer on the hub and thread the LNUT onto the axle and
tighten to 5-6 Nm
J
18